FAQs

Q: HOW DO I DETERMINE AN UNKNOWN IP ADDRESS?

Q: How Do I Test an AMCI SSI System?

Q: How Do I Test an AMCI Resolver System?

Q: Using a SMDXXE2 Absolute Encoder

Q: SMD34E2 Removing Main Power

Q: AMCI M12 Cordset Part Numbers, Wiring, and Cross Reference

Q: Why does my stepper motor run erratically?

Q: How Do I Reverse a Resolver's Count Direction?

Q: How can I use the 16 bit data from my Nexus unit with my 32 bit Network Scanner?

Q: What Causes the Resolver Counts to Vary or Jump?

Q: Can I Use Transducers From Other Manufacturers with AMCI Controllers?

Q: How do I choose between Single Turn, Geared Single Resolver, or Dual Resolver Transducers?

Q: What Transducer Cable Can I Use in High Temp or High Flex Appications?

Q: How Do I Calculate the Number of Turns Completed by a Resolver in the PLC?

Q: How do I program my 2600 module to simulate the Group Modes present in the 8500 and 8213 modules?

Q: How Do I program an AMCI SSI Interface Module to work with an Allen Bradley 842A Absolute SSI Encoder?

Q: How Do I Use an AMCI Block Transfer Module in a ControlNet Remote Rack?

Q: How Do I Connect AMCI Stepper Indexers to Rockwell Automation's Ultra 3000 Servo Drivers?

Q: How Do I Wire a Single-Ended Indexer Output to an AMCI Stepper Drive Differential Input?

Q: How Do I Generate "Velocity at Zero" and "Motion Direction" Bits in PLC Ladder Logic?

Q: How Do I Offset the Resolver Position in the PLC?

Q: How do I change the IP address of an AMCI Ethernet IP or Modbus TCP/IP device?

Q: Can I use an AMCI Stepper Module as a Frequency Generator?

Q: How Do I Use Ladder Logic Instructions to Communicate with an Ethernet IP Next Unit?

Q: How can I tell if my SSI sensor is not communicating with my AMCI SSI interface module?

Q: How do I add my AMCI module to a PAC Rx7i system?

Q: How do I address an AMCI Nexus unit in my Modbus TCP/IP network?

Q: Using AMCI’s Device Firmware Update utility

Q: Using AMCI Motion Axis AOI's with CIP Sync